I Had To Mention Cutting Boards

I Had To Mention Cutting Boards 5 comments

I was finishing up the 2nd round of routed bowls, and I mentioned that the process used to make the bowl blanks … building up the wood by gluing together several boards to get to the bowl dimensions … was the same as used to make cutting boards.

So, of course, I was asked to make a cutting board. And another. I ended up making 5 cutting boards and 3 cheese boards. Velda’s cutting board and cheese boards are discussed separately (link below). Here are the details on these 6x boards.

Alley and Christopher asked that their board be made in brown tones, so it is made from Walnut, Jatoba, Honey Locust, Tigerwood and Cherry. That board is 21″ long x 15-3/8″ wide x 1-1/16″ thick.

MrsMowry asked that her board be very red, so it is made from Purpleheart, Canarywood, Cherry and Hard Maple. That board is 14″ long x 12-1/4″ wide x 1-1/8″ thick.

I made two end grain cutting boards, as made famous by The Wood Whisperer. Fun project, though it’s definitely challenging to work on end grain like this. One is made from Walnut and Hard Maple; the other is Walnut and Yellowheart.

Finally, there’s a cheese board (PERFECT for the scraps that were left over!) which is 10-1/4″ long x 8-3/4″ wide and 1″ thick. The woods used are Cherry, Teak, Canarywood and Mahogany.

Selecting and arranging the boards is done with an eye towards grain, color and balance. This is also the time to inspect each board individually for any defects that might arise as the boards are planed down. Applying mineral spirits to the boards will give you a great look at the finished color of the boards.

Once the layout of the board is done, I taped the individual boards together until I was ready for the glue-up.

When you’re doing multiple projects simultaneously – the only way to be efficient! – organization is key.

The router table is the only way to get smooth & consistent handholds in place.

I did a 3/8″ roundover on each edge, as well.

After a great deal of sanding, it’s time to apply the finish.

I started with a double coat of mineral oil, and then did a topcoat of mineral oil and 25% beeswax. This topcoat will need to be re-applied regularly to keep the cutting boards water-resistant.

This is an end-grain cutting board: each board has been turned on end, so the knife will cut down on the grain, instead of across the grain. This design was made famous by The Wood Whisperer.