To do what I do in the shop, I buy lumber.
I have a problem.
When you buy wood, you’re buying a natural product that is not perfect. Wood has knots. Checks. Voids. Cracks. Part of the intrigue of the craft is figuring out what to do with each piece of wood: finding the perfect project for each piece. That sounds like fun … until you get a piece like this one.
Black Walnut, 8/4 stock, with a knot and void … on this side. Sapwood (the light colored, younger wood) showing on the right edge.
This is an end cut – the end of a big, long board that was left because it’s just a bit short. I primarily use 24″ lengths of “8/4,” or “eight quarter,” lumber to make large cutting boards. This end cut piece is … 23″ x 12-1/4.” If I use that with longer lumber, I just end up shortening the good pieces I pair it with into waste, so this piece has to wait for me to find another use for it. A perfect use.
And it’s been waiting a long time.
This is a financial decision, in part. This end cut board is 4 full board feet, so it cost about $40. You don’t just throw away $40.
The problem isn’t readily apparent on the front side of the board … but when you flip it over to look at the back, the challenge is apparent:
The small knot at the bottom doesn’t look too bad, though it goes completely through the board. However, the large knot at the top is a big defect that’s hidden inside the board and travels towards the other knot. I think. That entire chalk circle is waste … in the middle of the board.
When a cut off board is waiting for me to find inspiration, it lives in the shop in some nook or cranny until I can figure out what to do with it. The root problem for me is that I’m out of nooks. And crannies.
I have no space. No. Space.
That means boards that are waiting for me to find the “perfect use” sit out on the floor, leaning against a handy vertical, just waiting for me to trip over them. Or knock them over. Or have to move them so I can get at whatever is being blocked.
And then move them back again.
Yesterday, I’d had enough of this double defect board, and inspiration was not forthcoming. Doesn’t matter; time to cut it up and see what what’s what. I chalked the outline of the board, and ended up with one long piece that’s 4″ wide. I got 2x smaller rectangular pieces that will end up as routed bowls. Or something. And, I got a little bonus piece that … will find it’s way into a nook or cranny along with many other walnut pieces that look just like it.
I need a new plan.
Someday.
Long and skinny would be great for crackers or cheese. Small and short for paper clips, straight pins (yes, I sew and a hollowed piece would be useful), soap holders for when you want to use Mrs. M’s fabulous soaps to add a refreshing aroma to any room, business card holders, the options are endless.