Once you purchase a Soap Drying Rack, 2 big boxes will soon land on your front step.
Really big boxes. Together, they weigh about 75 pounds.
These are your instructions on how to insert the 8x bolts to assemble each unit. If you are stacking 2 units, then you’ll also have 4 bolts to attach the units together. That is all that is required!
Here is how you assemble your Soap Drying Rack(s).
- Open the boxes and lay out the top, bottom, sides, 8x trays and bags of hardware. If you bought a double rack, only open the boxes (that are labeled) with the bottom rack. No need to confuse yourself with more parts.
- Put the bottom on a flat surface. If you bought the Rack with wheels, then turn the bottom upside down so the wheels are facing up. Use your hands to press the tab down towards the wood and unlock the wheels. This will be much trickier after the unit is assembled, so unlock the wheels first. Note wheels are shipped in different colors, so I can’t always control which color is on your unit.
3. Flip the bottom back over, so it rests on the unlocked wheels.
4. Look for the letters that are handwritten on the outside of the boards mounted to the bottom. Now, find the side that has matching letters. When you place the side directly next to the mounted board, the 2x holes that are drilled beside the letters will line up. Use the 2-1/2″ bolts – the long ones. Put a single washer on the bolt, and then insert it from the outside of the unit so the bolt sticks through to the inside of the unit. Then, place another washer, split washer and nut back on to the bolt and make them finger tight.
5. Repeat with the other hole.
6. Repeat with the other side. Note: I always label every unit differently, so you must assemble the sides with the tops and bottoms as labeled and explained, below. It’s the only way it works!
7. Place the top of the unit on the sides so the letters match, and the holes will line up.
8. Insert bolts from the outside with one washer, then put the other washer, split washer and nut on the inside, finger tight.
9. Check a tray to make sure it fits on the rails and slides into the rack easily. Remove the tray(s).
10. Tighten all bolts.
11. Note: the bottom tray does not fit on runners like the other 6x trays. The bottom tray slides on the boards mounted to the bottom of the unit. You have to insert the tray a bit carefully at first, but once you get the hang of it, the bottom tray goes in smoothly.
12. If you bought a 2nd unit for stacking, then open the other 2 boxes.
13. Attach the bottom of the top unit to the top of the bottom unit (got that?) by matching the letters on the top and bottom. When the letters match, the holes for the top & bottom will match.
14. Insert a 2″ bolt (the shorter, thicker ones) with a washer on the bolt from below, sticking up through the top and the bottom. You may find that using a hammer to tap the bolt gently through the tight hole is helpful. Put a washer, split washer & nut on the exposed bolt. Make it finger tight.
15. Repeat for the other 3x holes.
16. Repeat steps 4 – 10 for the top unit.
Yes, I ship you 8x trays. The 8th tray is a bonus … and insurance in case one tray breaks in shipping. Plus, it fills the box nicely for shipping.
Enjoy, and get to making soap!
More
Leave a Reply